Petcube SupportPetcube CameraPetcube Camera LED is pulsing yellow and doesn't turn white after setup

Petcube Camera LED is pulsing yellow and doesn't turn white after setup

This problem may occur if you have entered an incorrect password for your home Wi-Fi network during registration. To change it, open the 'Settings' menu in the Petcube App, scroll down to 'Wi-Fi,' and follow the instructions to setup the connection again. Hold the start button on the back of your device for 3 seconds until the light turns green.

If that doesn't help, below are a few other possible reasons this could be happening:

  1. Your router might be set into WEP security encryption mode, which is not supported by Petcube due to security reasons. Petcube works with newer WPA/WPA2 encryption technology that aims to provide stronger wireless data encryption than WEP. We recommend changing security encryption to WPA/WPA2, which won't require you to reconnect the devices back to the network or change your password. To access your router settings, you may either call your ISP or look at the bottom of your router, it usually has the login and password for the router settings, or call our support team for assistance and we will be happy to help.

  2. Your router may have some security settings such as a firewall or MAC address filtering that don't allow Petcube to connect to the Internet. Call your ISP or Petcube support team for assistance.

  3. You have a WPS pin on your router, which works like a secondary Wi-Fi password that is not supported by Petcube due to security reasons as it is considered to be a vulnerability on the network. You may call your ISP or the Petcube support team to resolve this.

Was this article helpful?

Help us improve our Support Center