The LED is pulsing yellow and doesn't turn white after setup
This problem may occur if you have entered an incorrect password for your home Wi-Fi network during registration. To change it:
- Open the Petcube app.
- Go to the camera profile.
- Tap the 'Settings' wheel in the upper right corner.
- Choose 'Wi-Fi'.
- Find a reset pin that came with your device, find the small hole above the USB port on the left side if you're using the Petcube Bites 2 camera or at the bottom of your Petcube Play 2 device, insert the reset pin into it, hold it down for 3 seconds until the light changes to pulsing green and follow the steps on your screen.
Was this article helpful?
Help us improve our Support Center