Confirm your region to see content that is specific to your location and to shop in your currency.

Petcube SupportPetcube Bites 2 | Petcube Play 2 BLE | Petcube Play | Petcube Bites | Petcube CameraWhat ports do I need to open for Petcube on my firewall

What ports do I need to open for Petcube on my firewall

If you get this error message, firstly, make sure you have Internet access on your wi-fi by trying to open a few websites on a few devices. If you have Internet access but Petcube still can't be connected, try to reset the device by following these easy steps:

  1. First, if you have previously set up your Petcube, open the Petcube App, go to 'Home' tab, then select 'Settings' and choose 'Disconnect Camera'.
  2. Power up your Petcube, wait 1 minute until it starts up, then if you have Petcube Bites or Petcube Play, find a reset pin that came with your device, find a small hole with rest button on the bottom of your Petcube Play or below the USB port on your Petcube Bites, insert the reset pin into it, hold it down for 8 seconds until the Petcube plays a sound and release it. If you have a Petcube Camera, quickly press the start button on the back of your device 7 times in a row.
  3. Wait until the Petcube Bites or Petcube Play boots up again and starts blinking green. If you have a Petcube Camera, please switch it to setup mode by holding down the start button for 3 seconds until the LED changes to blinking green color.
  4. Open Petcube app, go to the 'Home' tab, select 'connect your device', pick your Petcube from the list of options and follow the steps on the screen.

If you want to have the firewall on, you need to open the following ports:

a) TCP port 3335; 34.194.225.22

b) TCP port 443; 35.212.7.2135.207.1.22 (You may not need the UDP ports because they’re rarely blocked, but UDP range should be from 7000 to 7100)

WPS pin code should be disabled (please note that not all the routers have it). MAC filtering should be disabled. If enabled, a MAC address can be found at the back of the cube.

    Was this article helpful?

    Help us improve our Support Center