Petcube SupportPetcube Play 2 BLEPetcube Play 2 factory reset instructions

Petcube Play 2 factory reset instructions

If you have a problem with your Petcube and need to reset it, follow these easy steps:

First, if you have previously set up your Petcube:

  1. Open the Petcube app.
  2. Go to 'Home' tab.
  3. Tap the 'Settings' wheel in the upper right corner.
  4. Choose 'Disconnect Camera'.
  5. Power up your Petcube Play, wait 1 minute until it starts up.
  6. Find a small hole on the bottom of your Petcube Play, insert the reset pin into it, hold it down for 8 seconds until the Petcube plays a sound and release it.
  7. Wait until the camera boots up and starts blinking green.
  8. Open Petcube app.
  9. Go to the 'Home' tab.
  10. Select 'Connect your device'.
  11. Pick your Petcube from the list of options and follow the steps on the screen.

Was this article helpful?

Help us improve our Support Center