Confirm your region to see content that is specific to your location and to shop in your currency.

Petcube SupportPetcube Bites 2 | Petcube Play 2 BLEPetcube Play 2 or Petcube Bites 2 can’t establish the cloud connection / No Internet connection

Petcube Play 2 or Petcube Bites 2 can’t establish the cloud connection / No Internet connection

If you get this error message, firstly, make sure you have Internet access on your wi-fi by trying to open a few websites on a few devices. If you have Internet access but Petcube still can't be connected, try to reset the device by following these easy steps:

  1. First, if you have previously set up your Petcube, open the Petcube App, go to 'Home' tab, then select 'Settings' and choose 'Disconnect Camera'.
  2. Power up your Petcube, wait 1 minute until it starts up, find a reset pin that came with your device, find the small hole above the USB port if you have Petcube Bites 2 or at the bottom if you have Petcube Play 2, insert the reset pin into it, hold it down for 8 seconds until the Petcube plays a sound and release it.
  3. Wait until the Petcube boots up again and starts blinking green. If you have a Petcube Camera, please switch it to setup mode by holding down the start button for 3 seconds until the LED changes to blinking green color.
  4. Open Petcube app, go to the 'Home' tab, select 'connect your device', pick your Petcube from the list of options and follow the steps on the screen.

If you have a firewall on your wi-fi network or you have a block on some ports, below is the list of ports that need to be open for Petcube:

  1. 67.228.165.226:3335/tcp
  2. 67.228.165.226:16384-32384/udp
  3. cube_ext_ip:7000-7100/udp (optionally, NAT)
  4. 52.0.95.32:443/tcp
  5. 34.195.161.50:443/tcp

Was this article helpful?

Help us improve our Support Center