Petcube SupportPetcube Play 2 | Petcube Bites 2Oh bummer setup error on Petcube Bites 2 or Petcube Play 2

Oh bummer setup error on Petcube Bites 2 or Petcube Play 2

If during the setup you're getting an 'Oh Bummer' error message, turn your Petcube off and back on, wait up to 1 minute until it boots up and starts blinking and start the setup process over again.

Keep in mind that if the LED light color isn’t blinking green at the start, you need to find a reset pin that came with your device, find the small hole above the USB port if you have Petcube Bites 2 or at the bottom if you have Petcube Play 2, insert the reset pin into it, hold it down for 3 seconds until the LED light switches to blinking green. Now you can start the setup from the beginning.

Was this article helpful?

Help us improve our Support Center