Petcube Wi-Fi network is not visible or 'Petcube Network Not Found'
This error message usually means that you didn't switch Petcube into wi-fi mode. Power your Petcube Camera off and back on and start the setup process over again. Open Petcube application, go to 'Home' tab and select 'connect your device'. Keep in mind that when you first power on your Petcube camera it glows solid yellow for up to a minute (although it may look light green). Wait 1 minute until it starts blinking then press and hold the Start button on the back and release it immediately after it changes the color. Follow the steps on the screen to complete the setup.
Was this article helpful?
Help us improve our Support Center