Petcube SupportPetcube BitesPetcube Bites factory reset instructions

Petcube Bites factory reset instructions

If you have a problem with your Petcube and need to reset it, follow these easy steps: First, if you have previously set up your Petcube, open the Petcube App, go to 'Home' tab, then select 'Settings' and choose 'Disconnect Camera'. Power up your Petcube Bites, wait 1 minute until it starts up, take a reset pin that came with your Petcube, find the small hole below the USB port on the left side of the Petcube Bites, insert the reset pin into it, hold it down for 8 seconds until the Petcube plays a sound. Release it and wait until the camera boots up and starts blinking green. Open Petcube app, go to the 'Home' tab, select 'connect your device', pick your Petcube from the list of options and follow the steps on the screen.

Was this article helpful?

Help us improve our Support Center